Supplies

7” of 5/8” satin ribbon-Oatmeal 30079370

1 qty. 3” x 1 ½” felt-Red 77676619

1 qty. 1” x 1” felt-Black 77646643

1 qty. pin back 77126987 or 77403337

Tools

Scissors ¼” circle punch 77178558

Pencil

Low temp. glue gun & glue sticks

Directions

Trace and cut out pieces from felt according to the patterns.

Glue the 2 red hearts together. Glue the partial paw print onto the bottom half of the heart (see pictured sample for placement). Using the hole punch, punch out 3 circles and glue it above the partial paw print.

Take the ribbon and fold it in half, making a loop at the midpoint and try to make both of the ends with the shiny side of the ribbon facing up. The shiny side will be the front of the pin. Overlap the 2 ends of the ribbon so that the 2 ends criss-cross over each other and apply a spot of glue where they overlap. Glue the felt heart with the paw print onto the front of the pin where the 2 ends of the ribbon overlap each other. Glue the pin back onto the back of the ribbon (dull side). Optional: Make a V-cut at both ends of the ribbon.