Supplies

1 qty. Wooden spring Closure Clothespin #30083901

1 qty. 1” x 4” Black Foamie #77613620

1 qty. 4” x 4” Yellow Foamie #77613505

1 qty. 5” x 6” Purple Foamie #77613497

1 qty. 4” x 4” Orange Foamie #77613521

1 qty. Black Chenille stem #77669721

Tools:

Pen/Pencil for tracing

Sharp Scissors

Low temp Glue Gun & Glue sticks

Diagram 1

Directions

Trace and cut out pieces from foamie according to the patterns.

Take the black chenille stem and bend in half. Twist a couple of times together at the center. Separate the ends. Take each end and curl inwards. Place behind the top of the body for the antenna and glue to the back of the body. Cut out shapes from the orange foamie and glue onto yellow wings. Make sure that you glue on the same amount on each matching wing

 Place the black body down the middle of the purple wings. Place the yellow wing pieces on top of the purple wings, following the pictured sample. Glue the wing pieces in place. Glue the body to the purple wings.

Stand the clothespin in front of you with the opening facing up. Place the butterfly alongside of the clothespin and center. Make sure that the bottom of the wings touch the surface and align with the clothespin. Glue the butterfly to the clothespin.

Open the clothespin and slip a photo or message in.