Supplies

1 qty. 3” x 4” Tan Foamie #30006585– head & body

1 qty. 2” x 2 ½” White Foamie #77613612 - wings

1 qty. ½” x ½” Black Foamie #77613620- nose

2 qty. 7mm Moving eyes #77600837

1 qty. Green Chenille stem #77674093

7 qty. 6mm Facet Beads – any color

1 qty. 12” of 1/8” satin ribbon –coordinating color

1 qty. 4” of Gold Tinsel stem

1 qty. 1” Pin back #77403337 or magnet #77622688

Tools

Pencil/Pen Sharp

Scissors

1/8” Hole Punch #77178541

¼” Hole Punch ##77178558

Low Temp Glue Gun & Glue Sticks

Diagram 1

Directions

Trace and cut out pieces from foamie according to the patterns.

Place the eyes on the center of the bear’s head. Glue in place. Use the ¼” hole punch and punch out one circle form the black foamie. Place under the eyes for the nose. Glue in place. Place the head on the body piece, slightly overlapping on the top. Glue in place. Use the 1/8” hole punch and punch along the edges of the wing pieces. Place the wings behind the body, refer to the pictured sample. Glue the wings in place.

Take the gold tinsel stem and bend into a circle. Twist the ends together. Place over on ear and glue to the back of the head for the halo.

String the facet beads onto the green chenille stem and space evenly. Bend the chenille stem in half and slightly twist together. Shape into a circle. Twist the ends together to form the wreath. Make a loopy bow with the 1/8” ribbon. Place the bow where the twisted ends meet and glue in place. Glue wreath to the front of the bear angel, place so that one paw is holding it.

Glue either a magnet or pin back behind the wings.