Supplies

30086832 BEADALON
30061131 WIRE GUARDIAN
30071749 CLASP
30071801HEISHI-4MM BEAD
30080723 BUTTERFLY WINGS
30033342 CRIMP BEAD 2.0MM
30095605 BRASS 6MMSPLIT RING
30095652 2 IN HEAD PIN

Tools
Crimper
PLIER-SPLIT RING
ROUND NOSE PLIER

Directions

MAKING BRACELET
Attach split ring to top left side of butterfly wing, Attach another split ring to the bottom left side of the next butterfly wing, starting from the bottom up. Proceed to do this on the right side of butterfly, repeat steps until you reach the desired length of your bracelet

ATTACHING CLASP TO BRACELET
String crimp bead through wire then through wire guardian Open the wire guardian & slide clasp into the wire guardian. Close the wire guardian and crimp to hold clasp in place. To attach to the butterfly bracelet, feed excess wire through crystal & heishi beads in a heishi, crystal, heishi pattern. Then string through the center of the butterfly and continue the pattern until the end of the bracelet. Once you have reached the end, add the other end of your clasp in the same fashion that you put on the first clasp (heishi, crystal, heishi, crimp bead, through wire guardian, back through crimp bead).

EARRING
Attach split ring to top left side of butterfly wing, Attach another split ring to the bottom left side of butterfly wing. Proceed to do this on the right side of butterfly. Repeat until you have three butterflies. On a 2 inch head pin, stack one heishi bead, one crystal, and one heishi on the bottom of the earring and between butterflies. Loop the top of the head pin and attach to ear wire.