Supplies

1 qty. Jumbo Flat Marbles – Crystal Clear #77766204

1 qty. Magnets – Button ¾” x 3/16” #30043930

Decoupage Glue (Royal Coat #77648964, Modge Podge, etc.)

E6000 Glue #1096239

Rubberstamps, ink & cardstock, stickers , photo, etc., for magnet image

Tools:

Sharp Scissors 1” – 1.5”

Circle Craft Punch

1” foam brush #10109

Directions

 Decide on the image you want for your magnet. You can use a photo, magazine clipping or you can rubberstamp an image on cardstock. Just do a small swatch test with the decoupage glue first, to make sure it doesn’t ruin the image. Use the circle punch to cut out the image. Place under the marble and use the scissors to trim off excess if necessary.

Use the foam brush to spread a thin layer of the decoupage glue onto the flat side of the marble. Place the marble on top of the cut out image and press down to squeeze out any air bubbles. Use the scissors to trim off any excess from the image if necessary. Brush a little more decoupage glue onto the bottom of the image and around the edges of the marble to seal in place. Let dry.

Attach the button magnet to bottom of the marble with E6000 glue. Let dry.