Supplies:
1 qty. Memory Wire Bracelet – Silver #30061087
1 qty. Memory Wire End Caps 5mm – Silver #30033353
1 qty. Small Pearl stands #30077279
1 qty. Gemstone Package – your color choice
GS Hypo Cement glue #30033326

Tools
Memory Wire Cutters #30061230

NOTE: Sample shown was made with the Aqua Gemstones package #30044387

Directions

 Measure out approximately 11” of Memory wire. Place a little Hypo Cement glue on the tip of one end of the wire. Place the bead cap onto the wire. Let glue dry so that the bead end cap will set.

Place you gemstone beads and pearls in the pattern sequence that you want for the bracelet. Slowly slide the beads and pearls onto the memory wire. Rearrange the beads and pearls as necessary until you are happy with the bracelet design. Trim off any excess wire, leaving about ¼” for the bead end cap.

Place a little Hypo Cement glue on the tip of one end of the wire. Place the bead cap onto the wire. Let glue dry so that the bead end cap will set.