Panda Pin
SUPPLIES:
1.75"
x 1.75" White Fun Foam
1.5" x 3" Black Fun Foam
1.75" x 2.5" Red Fun Foam
Two 7mm Moving Eyes
Black Fine Tip Permanent Marker
Pin Back
Low Temp Glue Gun and Glue Sticks
DIRECTIONS:
Trace and cut out the pieces from Fun Foam according to the patterns.
Glue the ears from behind the head. Glue the black eye patches onto the face. Glue the 7mm eyes onto the eye patches, toward the center. Glue the nose just below the eyes.
Place the heart at the bottom of the head and glue in place. Glue the paws on either side of the heart, as if the paws are holding the heart. Glue the feet at an angle on either side of the bottom of the heart.
Take the black permanent marker and write a name or message onto the heart. Glue the pin back behind the head.
