Santa Scrapbook Page
This project courtesy of Fiskars®.
|
Supplies Fiskars® ShapeBoss™ Embossing System Starter Set Fiskars® ShapeBoss™ Stencil Set Christmas Fiskars® Hand Punch - ⅛" Circle Fiskars® Self-Healing Craft Mat 12½" x 12½" Fiskars® Comfort Grip™ Micro-Tip® Scissors 12" x 12" scrapbooking background paper - tan plaid w/burgundy flecks 12" x 12" cardstock - deep red, sage 8½" x 11" cardstock - cream Rebecca Sower Nostalgiques Stickers - Cracked Glass Decorator's Chalk - red, sage Adornaments Craft Fibers - sage, burgundy Gold brad Eyelets - 10 red Eyelet setter Hammer |
|
|
Directions Using paper trimmer, trim photo to measure 3¼" x 5". Cut a piece of cream cardstock to measure 4⅛" x 8". Also cut a piece of sage cardstock to measure 4¼" x 10½". Tear approximately ½" away from bottom of each of these pieces. Insert cream piece between stencils on ShapeBoss tray. Across top (untorn) edge, emboss holly sprays and ribbon between. Remove embossed cardstock and lay onto work surface. Remove one stencil, flip over, and use stencil over embossed area to chalk embossed areas. Adhere cream piece to center of sage piece. Using hand punch, punch one hole in each of the two upper corners of the cream piece. Insert eyelet into each hole. Flip over onto craft mat. Insert eyelet setter into backside of eyelet. Tap two to three times onto setter until backside of eyelet begins to curl over. Remove setter and set aside. Tap gently one to two more times to finish eyelet. Repeat for second eyelet. Cut one piece of each sage and burgundy fibers to measure approximately 8". Thread each end through one eyelet in photo layers from back to front. Tie each end in a knot. Cut one additional piece of each sage and burgundy fibers to measure approximately 15". Wrap these pieces around bottom of torn layers. Using photo stickers, adhere photo to center of cream piece. Tear one edge of 12" x 12" sage cardstock piece to measure approximately 5" wide. Also tear one edge of 12" x 12" red paper to measure approximately 4½". Adhere first sage piece, then red piece along left edge of background paper. Cut a piece of cream cardstock to measure 2¾" x 2". Insert this piece between stencils on ShapeBoss tray. Emboss Santa hat in center of this piece. Using stencil, chalk hat top with heavy red chalk, then chalk ball and brim of hat using light chalk. Cut a piece of sage cardstock to measure 2-7/8" x 2⅛". Adhere cream piece to sage piece. Punch hole in each corner using hand punch and apply eyelet to each hole according to directions above. Cut a piece of cream cardstock to measure 3½" x 2½". Emboss and chalk sleigh in the center of this piece. Punch holes and apply eyelets to each corner according to eyelet instructions above. Using photo stickers, adhere sleigh and hat layers to red torn section.
Peel and apply stickers to spell out "SANTA
AND ME" between embossed layers, then apply year stickers below embossed
hat.
|
|
