Supplies

FISKARS® 12"/30cm Euro Personal Paper Trimmer 

FISKARS® ShapeCutter™ Tool 

FISKARS® ShapeTemplate™ Tool - Christmas-1 w/Icicle Border 

FISKARS® Self-Healing Craft Mat 12.5"x12.5" 

FISKARS® Texture Plate Spirit 

FISKARS® Texturing Tool 

FISKARS® Seagull Paper Edgers 

Sage card stock 

Gold pearl paper 

7/8” wide sheet sage ribbon 

Metallic Rub-Ons - Kit #2 brass,olive 

PSX Merry Christmas stamp #B-924 

All Night Media® Christmas Greetings stamp#580J11 

Stampendous® Peridot PearLustre™ embossing powder 

Embossing ink 

Embossing heat tool 

3D foam mounting squares 

Scissors, glue stick, cello tape, cosmetic wedge sponge, wax paper 

Directions

1. Using paper trimmer cut sage card stock to 5 ½” x 11’. Score using black blade on trimmer at 5 ½”, fold in half – top fold.
2. Place front of card down onto line texture plate. Using large tip, emboss 19 lines on the right side of card. Note: working on the inside of card, lines will be on the left of card front when flipped over.
3. Apply brass metallic rub-on to raised lines on card front using finger or cosmetic wedge.
4. Cut a 5” x 2 ¾” piece from sage card stock. Place onto stars texture plate. Rub card stock with texture tool to emboss/texture design.
5. Apply brass metallic rub-on to the raised design on opposite side. It is only necessary to apply rub-on around edges to create a border, as the center area will be covered. Adhere to center front of card.
6. Cut gold pearl paper to 4 ½” x 2 ¼”. Trim each corner using seagull edgers. Line up notch on edgers with the edge of paper.
7. Ink Christmas Greetings stamp with embossing ink. Stamp image onto center of gold pearl piece. Apply embossing powder, tap off excess. Heat with embossing heat tool.
8. Wrap 6” length of ribbon around stamped panel. Secure at back with tape. Adhere to textured panel on card front with 3D foam mounting squares.
9. For card inside, use ShapeCutter™ and Christmas template to cut ornament shape from gold pearl paper.
10. Place ornament shape onto stars texture plate. Rub with texturing tool on the outside edges. Apply olive metallic rub-on to raised areas on opposite side.
11. Stamp and emboss Merry Christmas image onto center front of ornament. Adhere to center inside of card.