Supplies

4” x 4” Shrink Plastic #30003143

Sand paper #30033492

Black Fine Tip Permanent Marker #77531954

Colored Pencils #77768376

Heat It Tool heat gun #30003773

Pinback #77403337 or77126987 or 3/4” button magnet #77622688

E-6000 Glue #77525881

Slipper Pattern

Optional: Glossy Varnish #77855858

Directions

Prepare shrink plastic by sanding both sides of the sheet. Wipe off the excess dust with a paper towel. Place the design under the shrink

plastic and trace with a black permanent fine tip marker.

Cut out the design from the shrink plastic very carefully. Cut into the curves and flip the plastic so that you do not have to bend any of it.

Bending the plastic can create tears in the plastic. Leave a small border around the design when cutting it out so that the design will stand out when it shrinks down.

Color the design using colored pencils. Color in decorative designs such as flowers to the slippers if you desire. Color both sides of the shrink plastic if you wan tit to be more vibrant.

Shrinking the plastic – follow the manufacturer’s directions for shrinking the plastic. You can either use a small oven or the Heat It tool

heat gun. If using the heat gun, use a wooden chopstick or similar to help hold the plastic sown when it is shrinking.

After shrinking, let cool. Optional: You can paint a coat of clear glossy varnish to seal in the colored pencils if you desire. Glue on the magnet

or pin back to either side.