Supplies

1 qty. 4 ¼” x 4 ¼” White Foamie #77613612

1 qty. 3” x 6” Black Foamie #77613620

1 qty. 1” x 2” Red Foamie #77613604

1 qty. ¾” x 1 ¾” Orange Foamie #77613521

1 qty. 1” x 2” Light Green Foamie #77613570

2 qty. 25mm Moving Eyes #30055161

2 qty. Mini Wooden Clothespins #77676577

2 qty. No-Roll Wooden Clothespins #77676569

Tools:

Scissors

Pen/pencil

¼” Hole Punch #77178558

Low Temp. Glue Gun & Glue sticks

Pattern

Directions

Trace and cut out pieces from foamies according to the patterns.

Place the two moving eyes in the center of the white foamie circle and glue in place. Place the orange nose below the eyes and glue in place. Use the ¼” hole punch to punch out 5 circles from black foamie. Place the circles below the nose in a half circle “smile” and glue in place. Place a red heart at each end of the smile ad glue in place.

Place the black hat across the top of the head and glue in place. Place the green leaves on the hat as shown in the pictured sample and glue in place.  Use the ¼” hole punch and punch out at least 3 circles from the red foamies for “berries”. Place the berries in the center of the cluster of leaves and glue in place.

Turn the snowman’s head over so that the backside is facing up. Place the two No-Roll clothespins onto the snowman with the rounded side facing up towards the hat. Align the other end of the clips with the bottom edge of the snowman’s chin. Keep the clothespins about an inch apart and glue in place. The snowman’s head should be able to stand up with the clothespins upright. Glue the two mini wooden clothespin behind the hat to clip a small card or photo for display.